Line Control Monitor Replacements for Metrox, MD Totco, LM-2000, & Others.

• Line Control Displays
• Line Control Software
• Installations & Applications

• LCI-90
• LCI-100
• LCI-90R
• Drum Counter
• Dual Tension
• LCI Quad
• Dual-Winch
• 4/8 Tension
• Options

• The LCI-90 and LCI-90R Have Been Designed as Drop-in Replacements for Existing Winch Monitors.
• Common Replacement Display for:
  • Metrox
  • MD Totco
  • LM-2000
  • Many Others

Replacement Monitor (PDF) LCI-90 Brochure (PDF) LCI-90R Brochure (PDF) LCI-90/90R Manual (PDF)

Metrox Replacement, MD Totco Replacement, LM-2000 Replacement and Replacement Displays For Other Monitors.

Here at Measurement Technology NW we’ve lost count of the number of clients who limped along with their old winch line monitors for years, not realizing how much of an impediment they were to fast, accurate, safe winch operation - until they upgraded to an new LCI-90 line control display.

Their reaction? "Wow." No more daytime visibility problems. No more issues with screen flickering, fadeout, or failure. No more frustration from new winch operators learning the quirks of a patched-together software system. No more EEPROM failures or serial communication errors. No more downtime because of panel failure and slow service response times.

Best of all, no more babying a device that was never designed to endure the kinds of conditions faced every day by oceanographic researchers, tugboat operators, offshore oil rigs, commercial and military ships, and fishing vessel crews around the world.

Please visit the LCI-90 and LCI-90R product pages or contact Measurement Technology NW for more information on replacement products and available services for older installations

Check out this product comparison to see if it's time to consider upgrading all your old LM-2000 displays to new LCI-90 monitors.
Standard Features	LM-2000 Monitor	LCI-90 Monitor
Operating Temperature	Temperature range is -20°C to 55°C	Temperature range is -40°C to 75°C
Front Panel Construction	Molded plastic	Stainless steel
Panel Window	Lexan film attached with doublestick tape	Glass coated Lexan, epoxy potted to panel
Pushbutton Construction	Plastic membrane switches	Fully sealed stainless steel pushbuttons
Input Voltage Range	Either 12 or 24VDC	18 to 36VDC
Display Viewing Angle	LCD, less than 90°	Electroluminescent, over 160°
Display Pixel Density	LCD pixel density 240x128	Electroluminescent pixel density 320x240
Input Modes	One analog input channel	Up to 4 analog inputs, 4-20mA or 0-5VDC
Menu Structure	Complex, non-intuitive navigation	Easy-to-use English language menus
Hardware/Software	Dual-axis load pin operation optional	Dual-axis load pin operation standard
Units of Measure	Switching units requires recalibration	Switch between Lbs/Kg at any time
Serial Ports	Serial communication is optional	RS-485 and RS-232 comm is standard
Serial Protocols	Single serial protocol available	Multiple serial protocols supported
Diagnostics	Diagnostic functions poorly supported	1 button push brings up diagnostic screen
Calibration	Tension input values are in A/D counts	Calibration units are actual sensor outputs